Feature:
1. The twophase hybrid stepping motor has a dynamic voltage of 12 to 48 V, a current of less than 5 A, and an outer Diameter of 35 to 86 mm.
2. The driver adopts the current loop subdivision control of the driver, the motor torsion ripple is small, the low speed operation is very stable, and there is almost no vibration and noise.
3. Highspeed torsion is much higher than other twophase drives, high positioning accuracy
4. Widely used in engraving machines, CNC machine tools, packaging machinery, etc.
5. Average current control, twophase sinusoidal current drive output and optoisolated signal inputoutput
6. The product has overvoltage, undervoltage, overcurrent and short circuit protection
7. The offline enable signal is valid, the drive fault is reset to disable any pulses, and the motor maintains torsion after the drive output power component is turned off.
8. The PC control signal can be either high or active low. Control signal when active high
9. The negative terminals together act as an active low signal, and the positive ends of all control signals are used together as a common signal.
10. The halfflow function is a 200ms step pulse, and the driver output current is automatically reduced to 50percent of the rated output current to prevent motor heating.
11. There must be 20mm space around, and it should not be placed adjacent to other heating equipment to avoid dust, oil mist, corrosive gas, excessive humidity and strong vibration.
Specification:
Item Type:
Input Voltage: DC 1248V Input
Input: 15A Current, Select Drive Stepper Motor
Output Current: 0.2A5A
Temperature Operating Temperature: 1045 celsius ; Storage Temperature 40 celsius 70 celsius
Humidity: No Condensation, No Drop
Gas prohibits combustible gas and conductive dust
Set the Number of Steps Per Motor Step for the Motor 200(synchronizing), 400 (2 segments), 1600 (8 segments), and 3200 Steps (16 segments).
Power Interface:
1. DC +, DC: Connect the drive power
DC +: DC Power Supply Level, Power Supply Voltage Dc 12 To 48v, Maximum Current 5a
DC: DC Power Supply Negative Level.
2. A + AB + B: Connecting TwoPhase Hybrid Stepping Motor
The connection between the driver and the twophase hybrid stepping motor and the fourwire system, the parallel and series connection of the motor windings, and the connection method, the highspeed performance is high, but the driving current is large (the motor winding current is 1.73 times), when the driving current is equal series connection when the motor winding current
Troubleshooting:
State Light Indication
RUN: The Green Light Works Normally.
ERR: Red Light, Power, Indicator Light, Power Indicator
Control Signal Definition:
PUL +: stepping pulse signal input side or positive pulse signal input positive terminal
PUL: Negative input of negative input pulse signal or positive pulse signal
DIR +: input the positive direction step direction signal or input positive terminal negative pulse signal
DIR: Negative terminal for step direction signal input or reverse pulse signal input in negative direction
EN +: Offline can reset the signal input
EN: Offline resettable signal input negative.
Package List:
1 x TB6600 Stepper Motor DriverThe twophase hybrid stepping motor has a dynamic voltage of 12 to 48 V, a current of less than 5 A, and an outer Diameter of 35 to 86 mm.
The driver adopts the current loop subdivision control of the driver, the motor torsion ripple is small, the low speed operation is very stable, and there is almost no vibration and noise.
Highspeed torsion is much higher than other twophase drives, high positioning accuracy
Widely used in engraving machines, CNC machine tools, packaging machinery, etc.
Average current control, twophase sinusoidal current drive output and optoisolated signal inputoutput
