Teucer 12V/4Pin PWM Black/White Adapter Cable 1 to 1/2/3/4 Computer CPU Cooler Fan Splitter PC Chassis Fan Extension Power Cable

High-concerned chemical : none Power Interface : 4PIN RGB Support : NO RGB Material : Copper,PVC Weight : 50g Type : PWM Controller/HUB Model Number : B1T3B1T3

TEUCER Origin : China

4Pin Fan Interface Extension Cable·PWM temperature control·PVC insulation·Copper wire Copper 4Pin Fan Extension CableNot easy to oxidize, anti-interference,long working life.Easy to use, Quality Assurance Connector Heat Shrink Tubing WrapThe protective wire is not easy to oxidize, and will not cause poor contact due to bending Good stability after long-term use. The outer layer is wrapped by a woven meshWoven shell for toughness and interference resistance. PVC insulationAll copper wire core, fastand stable transmission. 1. Provide three 4Pin PWM fan interfaces,supportautomatic speed adjustment of two 4Pin PWM fans.2. The braided outer layer design is used to facilitate the overall wiring inside the chassis and improve the overall aesthetics.3. Easily implement 4Pin PWM temperature-controlled fans in series, making full use of the limited number of motherboard 4Pin interfaces. Product Parameters[product name]:4Pin one point three fan interface extension cable[Product length]:29cm[insulation material]:PVC insulation[conductor material]:tinned copper[wire color]:black/white[Product interface]:one end of the motherboard is a small 4pin connector, and the other ends are fan small 4Pin interfaces[Product function]:Make three computer fans share one interface Function: Easily realize parallel connection of4PinPWM temperature-controlled fans,make full use of the limited number of motherboard 4Pin interfaces, and can expand and connect three 4PIN/3PIN fans. Important note: In order to avoid the signal conflict of simultaneous speed measurement, two of them are default speed measurement lines. That is to say, one of the 3separate interfaces has 4 pins (supports speed measurement and temperature control), and the other 2 has 3 pins (only supports temperature control).Reason: Because even fans of the same model may have different speeds, if you use one pin on the main board to measure more than two fans with different speeds at the same time, the main board will go on strike. The result is that the PWM and speed measurement functions of the two interfaces are invalid. Therefore, it is necessary to remove a speed measurement line from other interfaces, and only keep the speed of one fan, and other fans can also achieve the purpose of temperature control and speed regulation.