Applicable Scenes: aneous water heater is small in size, fast heating, simple and convenient to install, suitable for installation in kitchens, toilets, showers, public toilets, etc. Suitable for daily washing, washing hands, dishes, vegetables, face, bathing.
Temperature Adjustment: The temperature range of the water heater is between 30‑55 degrees. It can be turned on or off by remote control, and the temperature can be adjusted. It can also be controlled by the button of the machine.
Constant Temperature Water: Electric tankless water heaters provide continuous hot water at 30 degrees C or higher in an , without waiting for preheating or dreadful temperature rises and falls, making them the perfect companion for your sink.
Item Type: Water Heater
Heating Body: Aluminum Die Casting
Weight: Approx. 1900g Celsius 4.2lb
Power: 3000W
Frequency: 50-60HZ
Wire: 2.08
Waterproof Grade: IPX4
Product Size: Approx. 21x15x5.5cm Celsius 8.3x5.9x2.2in
Remote Control Power Supply: 2 Batteries (Not Included)
Temperature Range: 30-55 degrees C
Common Faults and Solutions:
1. Check whether the power supply is powered on normally, the indicator light on the power‑on display will light up to show the temperature, and it will not light up if it is not powered on.
2. Under normal power on conditions, the water is turned on, press the middle key, the machine starts heating, and the water heater displays: set temperature, water , outlet temperature.
3. If the temperature does not rise, there are two possibilities: one is that the temperature control (overheat ) inside the water heater jumps, press the temperature control to it. The other is that the heating pipe is faulty, and the heat pipe can be replaced.
4. If there is a display of no heating, the display shows the temperature, but the water and set temperature are not displayed, indicating that the water does not pass through the water heater, or the water pressure is too low, or the installation direction is wrong. Note that the water inlet and outlet must be installed correctly, but if the water If the pressure is enough, there is water and it does not heat, then check the at the water heater inlet, there may be something stuck in the , causing the water heater not to start.
5. It is recommended that the length of the water pipe at the water heater outlet should not exceed 3 meters. If it exceeds the length of the water pipe, there may be a water pressure difference, and the water pressure is not enough to start. (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10 meters, so that the water pressure reaches the start value).
Geld zurück bei Nichtlieferung
